July 15, 2024


Technological development

Unconventional Longboard Built From Single Slice Of Tree

Unconventional Longboard Built From Single Slice Of Tree

Normally, skateboards and longboards are made out of lots of laminated levels of wooden. This offers them a pleasing flex that makes a cozy ride. Nonetheless, it is not the only way to do points. [DesignCo] went for an unconventional design and style, using a large slice out of a tree alternatively.

The gain of employing a part of tree trunk for a board is that it has a quite desirable appear with all the rings obvious. To switch it into a board, it was first roughly slash to form, before getting planed down to a uniform thickness. Additional shaping was then accomplished with the use of a flap wheel on an angle grinder. The wooden was concluded with several coats of tung oil prior to becoming specified a closing seal with matte lacquer. A good metal tail was then prepared to match, shaped with an nice curve and with two bolts screwed in. These bolts ended up then epoxied into the board, joining the two, and trucks installed underneath.

The remaining develop seems to be gorgeous, and is ride-ready too. It’s very likely a minimal slipperier than a board with grip tape, and it almost certainly would not manage bumps as nicely as a traditional design. Prolonged boards are rarely about functionality anyway, even though, and this board appears to be like like great enjoyable to get all-around on.

We have found non-common longboards right before, far too. Video after the split.